darknight
11-02-12, 17:08
I just got my LaRue LT129 cantilever mount in.
I followed the instructions of LaRue and tightened the screws on the LT129 mount around the Aimpoint Pro.
But...there is still a gap around the top (looking overhead/down-see pic) part where the LT129 ring won't come flush. I can only tighten it so much..as it is I tighten pretty hard!
Should there be a slight gap or should I tighten it till its flush with no gap.
What do you think?
I followed the instructions of LaRue and tightened the screws on the LT129 mount around the Aimpoint Pro.
But...there is still a gap around the top (looking overhead/down-see pic) part where the LT129 ring won't come flush. I can only tighten it so much..as it is I tighten pretty hard!
Should there be a slight gap or should I tighten it till its flush with no gap.
What do you think?