Dave L.
02-26-08, 19:28
I'm sure it's my fault;
I installed a KNS precision gen 2 hammer/trigger pin kit on my new 6920.
I noticed the trigger pin was a hair wider than the receiver- so it's somewhat loose there but not much.
If I pulled the trigger and immediately released the trigger it fired a 2 round burst, if I pulled the trigger and held it in it would fire 1 round, but when I released the trigger for the reset it would fire a 2 round burst.:confused:
Any one have the answer before I hand it to a smith?
I was using Blackhills 55gr. FMJ/Pmags.
I installed a KNS precision gen 2 hammer/trigger pin kit on my new 6920.
I noticed the trigger pin was a hair wider than the receiver- so it's somewhat loose there but not much.
If I pulled the trigger and immediately released the trigger it fired a 2 round burst, if I pulled the trigger and held it in it would fire 1 round, but when I released the trigger for the reset it would fire a 2 round burst.:confused:
Any one have the answer before I hand it to a smith?
I was using Blackhills 55gr. FMJ/Pmags.