mat10x
01-12-13, 01:57
hey guys,
recently picked up an '81 HK91.
came with a port buffer installed...but whoever put it on there didn't put it in the right spot. rubber pad of the port buffer should have been placed over the rear flange of the ejection port. instead the pad is sitting behind the metal flange of the ejection port.
did a few google searches but nothing specific.
tried to use an old credit card to slip under the port buffer to get it off without damaging the finish. no good. doesn't even budge.
any ideas?
thx.
14833
recently picked up an '81 HK91.
came with a port buffer installed...but whoever put it on there didn't put it in the right spot. rubber pad of the port buffer should have been placed over the rear flange of the ejection port. instead the pad is sitting behind the metal flange of the ejection port.
did a few google searches but nothing specific.
tried to use an old credit card to slip under the port buffer to get it off without damaging the finish. no good. doesn't even budge.
any ideas?
thx.
14833