Recipe for 6.8?

[tommyh]

I have two different uppers; noveske16" and bison armory, both stainless. Ive asked st 68forums but no replies.

Looking for a starting load for 95gr ttsx cci400,and re10x powder. All wrapped up in virgin brass! Any advice seeing as how finding anything is an act of congress now? I have some of each on hand.

[jstone]

Load data for the ttsx is the same as the tsx. So just look up the load data for the 95tsx. Barnes has stated that load data is the same for both bullets.

If you do not own a Barnes book just go to there website.

[CodeRed30]

I'd recommend using CCI #41 primers and Accurate 2200 powder. Also, what brass are you using?

[AKDoug]

I've gotten very good results with 29gr of 10x with Barnes 95's. Using Hornady brass and Federal match primers. Barne's load data on their webpage is woefully inadequate. They don't even list their 95's.

[sgedicks]

search the reloading data on 68 forum, I don't use the 95 gr personally, I'm sticking with the 110gr and up in 6.8's (hunting loads). I think I have seen that powder and bullet combination a few times, check the sticky posts in the reloading section, its probably there. I use AA2200 and H322 in my 6.8's.

ETA: this is what you may have been looking for - http://68forums.com/forums/showthread.php?26980-95gr-Barnes-TTSX-info