View Full Version : Virgin Barrel + FSB
Who is the go-to these days for drilling a new FSB and barrel?
I e-mailed steve at adco and got no response. I'm building an upper from scratch and this step is the only part I don't have the tooling for.
Thanks!
I've always heard ADCO. You shouldnt have any issues contacting Steve. I emailed him last week and got a response same day but i ended up finding someone local that did a good job. I believe Ranier Arms does some services as well
I'll certainly give Steve another shot. I've heard good things so, ADCO was my first notion.
Unless someone local comes up sooner (i.e. on this board) :cool:
I just had Adco pin an fsb for me. I made an error with my cc info so that delayed things :o but normally the job would be about a one week turn around. Just follow their instructions on the site, submit an order online and mail them your stuff. I would recommend including your own taper pins as the ones used on my barrel were a little short, at least for my liking.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.