View Full Version : Cantilever mount for my m4
Harrisboy2
10-29-13, 09:58
I have the standard a2 m4 gas block on my rifle and was looking into a scope and wanted to know how high does it need to be mounted to get a clear view over the gas block? How tall does the cantilever mount need to be?
SpankMonkey
10-29-13, 10:03
If you place the scope to high your chin will be off the stock. With a 3x or more powered optic, you will not see the tower. You will see a shadow in the bottom/lower scope window.
Harrisboy2
10-29-13, 10:08
If you place the scope to high your chin will be off the stock. With a 3x or more powered optic, you will not see the tower. You will see a shadow in the bottom/lower scope window.
Thanks I wondered if it would do that. Any good cantilever mounts you suggest for a 3-9x32 scope?
wetidlerjr
10-29-13, 10:15
Thanks I wondered if it would do that. Any good cantilever mounts you suggest for a 3-9x32 scope?
Bobro
Go to: BOBRO (http://www.bobroengineering.com/browse/category/scope-mounts/)
I have a 1.5X ACOG in a Larue mount and the FSP is 'visible', but it's not an issue. It's a bit fuzzy and not any kind of distraction. You should be fine with any quality mount that allows for proper eye relief and cheek weld.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.