KingsideRook
04-09-14, 14:11
This is a custom gunsmith-built Midlength-gas Dissapator upper. Barrel is pristine, never fired, Nickel-Boron upper receiver it's built onto is very lightly used at 30-60 rounds. Took a while to get all of these parts together, so I used an upper I had on hand, but everything else is 100% new. Unlike the cut-down rifle-gas dissipators, this is a mid-gas upper and will run as well as any other mid-gas CHF upper!
Specs:
FN Manufactured CHF Midlength Gas Dissapator 16" barrel, with M249 double-thickness Chrome lining, Sold by PSA.
Troy Low-profile gas block under the handguards
Arms #41-B Folding front sight at the handguard cap
Magpul MBUS Pro Rear Folding Sight
WMD Guns Nickel Boron Coated A3 Upper with M4 Ramps, Factory Coated Black on Exterior.
Magpul MOE Rifle Length Handguard
Magpul MVG Grip
Magpul Short 1913 Rail Section for Light
AAC Single Chamber Muzzle Brake - shortest muzzle device I could find and very effective.
IWC QD Sling swivel socket inset into left rear of MOE handguard
http://i.imgur.com/K4IjoFq.jpg
http://i.imgur.com/KJJdJ8F.jpg
http://i.imgur.com/fswLffA.jpg
This upper cost about $720 new to assemble, as I was trying to build a really top-end Dissy upper, but have to sacrifice it for another project. Asking $529 shipped for the entire setup, or $449 without the rear MBUS Pro Sight. The only wear on the entire upper as a few tiny places where the upper shows a little of the Nickel Boron finish underneath the factory black Duracoat at the takedown pin holes.
Email me with any questions, I'll see them faster than IMs. Purchase with confidence. Will listen to reasonable offers, but not really looking for trades right now.
Specs:
FN Manufactured CHF Midlength Gas Dissapator 16" barrel, with M249 double-thickness Chrome lining, Sold by PSA.
Troy Low-profile gas block under the handguards
Arms #41-B Folding front sight at the handguard cap
Magpul MBUS Pro Rear Folding Sight
WMD Guns Nickel Boron Coated A3 Upper with M4 Ramps, Factory Coated Black on Exterior.
Magpul MOE Rifle Length Handguard
Magpul MVG Grip
Magpul Short 1913 Rail Section for Light
AAC Single Chamber Muzzle Brake - shortest muzzle device I could find and very effective.
IWC QD Sling swivel socket inset into left rear of MOE handguard
http://i.imgur.com/K4IjoFq.jpg
http://i.imgur.com/KJJdJ8F.jpg
http://i.imgur.com/fswLffA.jpg
This upper cost about $720 new to assemble, as I was trying to build a really top-end Dissy upper, but have to sacrifice it for another project. Asking $529 shipped for the entire setup, or $449 without the rear MBUS Pro Sight. The only wear on the entire upper as a few tiny places where the upper shows a little of the Nickel Boron finish underneath the factory black Duracoat at the takedown pin holes.
Email me with any questions, I'll see them faster than IMs. Purchase with confidence. Will listen to reasonable offers, but not really looking for trades right now.