PDA

View Full Version : AICS questions



theJanitor
06-04-08, 18:38
i'm planning to put my 700 PSS action into an AICS 1.5 stock, but what else do i need to do to make this work?

Do i need a different bottom metal setup or does that come with the stock?


thanks,

Kent

mark5pt56
06-04-08, 20:34
To my knowledge, the AIC chassis comes with everything you need. You might have to add a bipod adapter unless they started including that.

theJanitor
06-05-08, 16:15
thanks guys, i'm ordering one right now.

williamTkilla
06-05-08, 20:42
My AICS that is new and still sitting empty has the bipod adapter on it already.

Renegade
06-06-08, 00:00
i'm planning to put my 700 PSS action into an AICS 1.5 stock, but what else do i need to do to make this work?

Do i need a different bottom metal setup or does that come with the stock?


thanks,

Kent


To properly install it you will need a Torque Wrench.

Make sure you know the difference between S/A & L/A.

RedMan*
06-06-08, 00:13
.............

theJanitor
06-06-08, 13:20
Make sure you know the difference between S/A & L/A.

thanks for the help guys. i was really just worried about the bottom metal.

my 308 is going into this. my 300WM PSS is staying in it's current stock. that one is getting too expensive to shoot.

Perryguy
06-06-08, 13:21
You will need a long (I think 6") Allen key. You can get what you need from Sears!

mark5pt56
06-08-08, 18:10
Remember to keep checking torque on it the first few rounds. there should be included instructions as to the proper round count and retorqing procedures.

kjo
06-09-08, 18:55
+1 on the long allen wrench; the screws that you will need to reach are recessed up into the aics frame. i found mine thru an internet search on egay.

kjo

theJanitor
06-12-08, 00:30
ok, the stock just arrived and it seems that my rings are too low. what height rings are you guys using on your AICS weapons?

Perryguy
06-12-08, 00:41
Ring height depends entirely on your scope...

theJanitor
06-12-08, 03:13
yeah, i just took the whole action, scope included, out of my PSS stock and bolted it into the AICS and the scope is too low. i was wondering if you guys went to the med or high rings when converting to this stock.

i think i need to go to high rings.