how is the troy 10"mrf-mx

[outdoorsmen]

is this a good rail setup? will i need a low profile gas block or do you think it will go over my bushmaser orc?

[C4IGrant]

is this a good rail setup? will i need a low profile gas block or do you think it will go over my bushmaser orc?


This is a good rail for a user to install. I prefer a one piece FF as they much lighter.

The Troy rail will fit over your shaved GB.


C4

[outdoorsmen]

I'm new to all this. what is shaved?

the troy is not one piece? is a one piece better? who makes one?

[C4IGrant]

I'm new to all this. what is shaved?

the troy is not one piece? is a one piece better? who makes one?

You have a cut down front sight tower.

Troy is 2 piece. One piece FF rails are lighter and stronger. The down side is that you need special tools to install them.

Daniel Defense and LaRue Tactical make the best one piece FF rails.


C4

[Robb Jensen]

'Shaved' FSB which makes it into a 2 pinned low profile gas block.


This will fit under a Troy:

http://img.photobucket.com/albums/v408/gotm4/virginiaarmspics/3gunrifles014.jpghttp://img.photobucket.com/albums/v408/gotm4/virginiaarmspics/3gunrifles015.jpg

The muzzle device on this barrel is permanently mounted so I had to 'shave' it while it was on the barrel, then refinished with flat black Norrells.
http://img.photobucket.com/albums/v408/gotm4/virginiaarmspics/shaveFSB003.jpg

This will fit under a Daniel Defense Lite Rail, with taper pins sometimes one or both pins need to be shortened.

http://img.photobucket.com/albums/v408/gotm4/virginiaarmspics/dd656eec.jpghttp://img.photobucket.com/albums/v408/gotm4/virginiaarmspics/adfe3166.jpghttp://img.photobucket.com/albums/v408/gotm4/virginiaarmspics/881e696c.jpg

With straight pins like LMT, RRA etc they're usually short enough not to contact the rail.