.875 ID gas block question

[MudBug]

is there a low profile .875 ID lowpro gas block that will fit under a Larue 13.2?

If not, how much extra room is there under a Samson, or other.

The PRI gas block that came with my 22" Grendel barrel is just barely too big to fit under my LT 13.2. (grrrrr)


ETA: just notice Larue makes one, who has it in stock?

[Boom]

Mudbug call LaRue they should have it in stock.

[MudBug]

Mudbug call LaRue they should have it in stock.


They show it as OOS, but Noveske had one, they shipped it right away.

I'm assuming that this should fit under their rails, but do you have any personal experience with the .875 ID versions? Do they indeed fit?

[Todd.K]

The LT .875 gas block will fit under a LT 13.2 rail.
It WILL NOT fit through the rear part of the handgaurd. So the handgaurd goes on first (not tight) then the GB goes into it. You will have to move the handgaurd so you can tighten the GB set screws through one of the holes in the bottom of the handgaurd.

Hope that helps
Todd

[MudBug]

The LT .875 gas block will fit under a LT 13.2 rail.
It WILL NOT fit through the rear part of the handgaurd. So the handgaurd goes on first (not tight) then the GB goes into it. You will have to move the handgaurd so you can tighten the GB set screws through one of the holes in the bottom of the handgaurd.

Hope that helps
Todd


Crap, I think I could have done that with the PRI that came with my Grendel kit.