Amicus
11-15-15, 16:12
I'm thinking about picking up a KMR, and have a couple of questions:
1. What is the KMR barrel nut made from (steel aluminum, other)?
2. Is the drive square on the included wrench made for a 1/2" or a 3/8" torque wrench?
Just due diligence stuff. I tried asking the source, but that did not work out.
1. What is the KMR barrel nut made from (steel aluminum, other)?
2. Is the drive square on the included wrench made for a 1/2" or a 3/8" torque wrench?
Just due diligence stuff. I tried asking the source, but that did not work out.