khurrle
01-11-16, 13:52
My lovely wife bought me a new toy for Christmas so I decided to do a review of it and put it out here for all of you to see.
Gerber Short Stack Multitool
MSRP
54.00
Specs:
Length: 2.9” / 7.4cm
Weight: 2.8oz / 80g
Tool Material : 410 Stainless Steel
The whole thing will fit in a Magpul MOE or MIAD grip
Features
Front Sight Adjustment Tool
Firing Pin Scraper
Bolt Carrier & Bolt Scraper
Cleaning Cable Pull-Through Handle
Buffer Tube Wrench
4mm Wrench / Bit Driver
7mm Wrench for M-LOK Fasteners
1/2“ Wrench
3/8” Wrench
3/4“ Wrench
Curved Slotted Driver
(2) Two-Sided Hex Bits (#0 Cross Driver, T10, 1/8” Hex, 4mm Hex)
Use:
I was able to use it a fair amount and only found two gripes.
1, The torx head that is included is for torx heads only. It is close to the size of the hex bit you would use for keymod accessories but is just a hair too small and when I tried to use it for them it rounded a bit. (this is most entirely my fault as its not really intended to be used for hex heads)
2, The 3/4" wrench for flash hiders is either slightly out of spec or just to thin to really use for tightening down flash hiders as mine rounded the cutouts both times I tried to use it.
Both of these are minor and should not detract from the fact that this is not really intended to be a primary tool but a secondary kept for just in case
Likes:
Size
Amount of tools
Fits in your Magpul grip
Design
Dislikes:
The issues mentioned above with the 3/4" wrench and torx bit
Overall 4.5/5 stars.
Video review here:
https://youtu.be/uVSkT2gz8w8
Gerber Short Stack Multitool
MSRP
54.00
Specs:
Length: 2.9” / 7.4cm
Weight: 2.8oz / 80g
Tool Material : 410 Stainless Steel
The whole thing will fit in a Magpul MOE or MIAD grip
Features
Front Sight Adjustment Tool
Firing Pin Scraper
Bolt Carrier & Bolt Scraper
Cleaning Cable Pull-Through Handle
Buffer Tube Wrench
4mm Wrench / Bit Driver
7mm Wrench for M-LOK Fasteners
1/2“ Wrench
3/8” Wrench
3/4“ Wrench
Curved Slotted Driver
(2) Two-Sided Hex Bits (#0 Cross Driver, T10, 1/8” Hex, 4mm Hex)
Use:
I was able to use it a fair amount and only found two gripes.
1, The torx head that is included is for torx heads only. It is close to the size of the hex bit you would use for keymod accessories but is just a hair too small and when I tried to use it for them it rounded a bit. (this is most entirely my fault as its not really intended to be used for hex heads)
2, The 3/4" wrench for flash hiders is either slightly out of spec or just to thin to really use for tightening down flash hiders as mine rounded the cutouts both times I tried to use it.
Both of these are minor and should not detract from the fact that this is not really intended to be a primary tool but a secondary kept for just in case
Likes:
Size
Amount of tools
Fits in your Magpul grip
Design
Dislikes:
The issues mentioned above with the 3/4" wrench and torx bit
Overall 4.5/5 stars.
Video review here:
https://youtu.be/uVSkT2gz8w8