ace4059
03-28-16, 22:47
If you have an RCBS vibratory tumbler can you look at the bottom through the vent and see if the fan is directly over the long screw that hold the bowl on, or is the fan offset 2" to the side of the main screw that holds the bowl on?
RCBS was gracious enough to replace my motor. Great CS BTW. I got it in the mail today and I replaced my motor on my tumbler and cant remember if it installs over the center of the screws or is offset. I should have took a picture before I removed it. It will install both ways. Inline is smoother running and offset is more tumbling but violent. If I get it wrong it could be either less cleaning action or worse wear out the bearings in the motor quickly.
ETA: if you could post a pic that would be greatly appreciated.
RCBS was gracious enough to replace my motor. Great CS BTW. I got it in the mail today and I replaced my motor on my tumbler and cant remember if it installs over the center of the screws or is offset. I should have took a picture before I removed it. It will install both ways. Inline is smoother running and offset is more tumbling but violent. If I get it wrong it could be either less cleaning action or worse wear out the bearings in the motor quickly.
ETA: if you could post a pic that would be greatly appreciated.