Can someone measure their Aimpoint T1?

[patriot_man]

Trying to figure out if I have enough room to mount a T2 to my Glock slide.

If anyone can measure from center-line of the front thread to the objective end of the sight that'd be great.

A second measurement of the objective "barrel" would be great too but not necessary.

Thanks

http://i.imgur.com/0o7x08n.jpg

[Scalarworks]

Trying to figure out if I have enough room to mount a T2 to my Glock slide.

If anyone can measure from center-line of the front thread to the objective end of the sight that'd be great.

A second measurement of the objective "barrel" would be great too but not necessary.

Thanks

http://i.imgur.com/0o7x08n.jpg

Centerline of front screw holes to front of sight (without lens caps on) is 14.0mm.

The front cylinder protrudes 5.86mm from the body (again, without the lens cap on).

Hope that helps.

[patriot_man]

Thank you!