Canonshooter
06-05-16, 05:04
I just restocked my 700 SPS Tac (in .308) in the Hunter 700 with Magpul's DBM system. I started off with 55 inch-pounds and groups seem just a touch looser than what I was getting with a B&C stock torqued to the same value. I'm going up to 60 inch-pounds for my next range session.
Realizing every rifle is different, I am curious nonetheless if anyone has experimented with different torque values with this stock and what has worked for best for you. FWIW, when I tighten and torque the action screws I have the rifle resting vertically on the recoil pad (muzzle up) to ensure the recoil lug is fully seated in the block.
TIA for any feedback!
Realizing every rifle is different, I am curious nonetheless if anyone has experimented with different torque values with this stock and what has worked for best for you. FWIW, when I tighten and torque the action screws I have the rifle resting vertically on the recoil pad (muzzle up) to ensure the recoil lug is fully seated in the block.
TIA for any feedback!