Shellen25
05-14-17, 21:05
Please read carefully:
This block had a seized metering screw. It was drilled out / burr grinder - however the threads were impacted.
I do not have taps/dies to further fix this; tap it and put in a new metering screw.
The ball detent is gone and this does not have set screws with it.
This can be a good instructional piece or if you want to try to fix it further, go to town.
There is a smudge of loctite on the bottom of the block I didn't bother to clean off.
13 shippedhttps://uploads.tapatalk-cdn.com/20170515/103299769f1c68779e2718fdf83ca888.jpghttps://uploads.tapatalk-cdn.com/20170515/ef3ff4a7224575c19b961d14f6cb91a1.jpghttps://uploads.tapatalk-cdn.com/20170515/10f8350b6a4fba08005d44f5cfa28679.jpghttps://uploads.tapatalk-cdn.com/20170515/6c3fd4d9ea4c6e8a9d84c199b23934e5.jpg
Sent from my SM-G935V using Tapatalk
This block had a seized metering screw. It was drilled out / burr grinder - however the threads were impacted.
I do not have taps/dies to further fix this; tap it and put in a new metering screw.
The ball detent is gone and this does not have set screws with it.
This can be a good instructional piece or if you want to try to fix it further, go to town.
There is a smudge of loctite on the bottom of the block I didn't bother to clean off.
13 shippedhttps://uploads.tapatalk-cdn.com/20170515/103299769f1c68779e2718fdf83ca888.jpghttps://uploads.tapatalk-cdn.com/20170515/ef3ff4a7224575c19b961d14f6cb91a1.jpghttps://uploads.tapatalk-cdn.com/20170515/10f8350b6a4fba08005d44f5cfa28679.jpghttps://uploads.tapatalk-cdn.com/20170515/6c3fd4d9ea4c6e8a9d84c199b23934e5.jpg
Sent from my SM-G935V using Tapatalk