View Full Version : Defective product(s)?
itsmcgavinson
02-10-18, 13:16
I tried to install a B5 Systems Gripstop KeyMod on my BCM KMR, but was unsuccessful. It seems that no matter how tight I screw the Gripstop on my rail there's significant wobble. Doesn't matter which portion of the rail I try it on. Anyone have any input on this?
Is there a chance that the screw in either of the KeyMod nuts is bottoming out on the gas block? Is the flat on the KMR flat. I have seen some buggered up rails where the owner didn't engage the lug before tightening the accessory.
I had an old Lanco Tactical Gripstop, same thing.
Mine came with two different sets of feet/nuts. Are you sure you are using the Keymod nuts?
Sent from my Pixel 2 using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.