Dillon 650 and primer problems

[ubet]

All of a sudden my 650 has started turning primers sideways then crushing them. Any idea as to what is causing this? https://uploads.tapatalk-cdn.com/20180622/2b42c0bb1ebc9f397c1146527797f882.jpg

Sent from my SM-N950U using Tapatalk

[markm]

Typically a bounce/jog in the machine causes the primer to flip in the cup. My 550b did that shit all the time. I no longer use the priming system.

Usually a thorough cleaning of the moving parts will smooth it out.

[tb-av]

If it's all of a sudden then I would clean and oil all the parts. Look for something bent or sticking. I'm not sure if the spring in the primer hold could wear out or not. I guess it could get stuck from residue
though.

I've never had that problem and .45acp was really the only thing I ever actually liked to load. It just seemed to always work. This was on a 550b though.

Do they still do the lifetime warranty? I broke a little piece once and they basically said "what's your address?" and sent me the whole part when all I needed was one little plastic piece.

I can't recall how that primer thing works but I know on mine it moved forward and backward. I assume it was on a rod or bushing. will yours move side to side? It seems like a bushing or shaft that rides on could wear over time to where it rocks and maybe mis-loads resulting in mis-seating.

[Ready.Fire.Aim]

There is a small thin arm that holds the case in place and aligned at the primer station.

Check to see if it has lost its tension and not keeping the case in place when the primer seats.

Also keep a can of compressed air handy and blow out any debris.

Good luck, primer station is my number one issue I tinker with on my 650.

[ace4059]

I wish I had an answer for you. I’ve been chasing this one for a few years now. It happens both on my 1050 and 650. Approximately 2 per 100 on the 650 and up to 10 per 100 on my 1050. Dillon can’t diagnose it over the phone for me. I’ve just accepted it as part of quality control and check for it before loading.

[ubet]

It had not done this since I got it, 18 months ago until the last 200 pistol rounds. I'll try some of the things suggested, and report back

Sent from my SM-N950U using Tapatalk

[panzerr]

If the shell plate is loose it can lead to flipping primers. Tighten down the shell plate bolt until the shell plate almost doesn't want to rotate then back it off a hair.

[ubet]

If the shell plate is loose it can lead to flipping primers. Tighten down the shell plate bolt until the shell plate almost doesn't want to rotate then back it off a hair.I had done that, and it still flipped them.

Sent from my SM-N950U using Tapatalk

[panzerr]

I had done that, and it still flipped them.

Sent from my SM-N950U using Tapatalk

So much for that quick fix! Have you tried yelling "****" a bunch of times? That seems to work for me, albeit intermittently.