View Full Version : Magclip question
Captains1911
07-31-18, 11:02
I was trying to install these on pmags to see how I liked them, and they seem to small to fit. No matter how hard I squeeze them together I can’t get them even close to be being able to start threading the screw. Am I missing something.
https://s26.postimg.cc/9jw8nd2op/7288259_C-_CE27-414_D-_A10_F-_C0_B9_DA7_A17_D2.jpg
dreamcrusher8307
07-31-18, 11:22
From their website:
https://cryeprecision.com/ProductDetail/accmc100000_magclip-set-of-3
"NOTE: CURRENT MAGCLIP™ IS NOT COMPATIBLE WITH MAGPUL® PMAG® GEN M3™ MAGS."
dreamcrusher8307
07-31-18, 12:35
Just also noticed that it's a 300blk mag. I'm not sure about the external geometry, but I know the internal is different in those, so that may be part of the problem as well.
crye's site says NOT compatible with Gen 3 mags. The only 300 mags MagPul sell are Gen 3 to the best of my knowledge.
Captains1911
07-31-18, 14:30
Just also noticed that it's a 300blk mag. I'm not sure about the external geometry, but I know the internal is different in those, so that may be part of the problem as well.
I tried it on 5.56 Gen3 pmag with the same result.
Captains1911
07-31-18, 14:31
crye's site says NOT compatible with Gen 3 mags. The only 300 mags MagPul sell are Gen 3 to the best of my knowledge.
Ok thanks, I missed that.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.