View Full Version : Aimpoint PRO height vs. magnifier height question
How close do magnifier and dot centerlines have to be to avoid problems?
I have a PRO & QRP2 combo that is 1.535" rail top to center, but haven't found any magnifiers of the same height.
Not as exact as you might expect. I have a PRO in ADM lower1/3 and a M4s in a Larue lower 1/3. Both are 2-3mm off center from my Vortex magnifier set up for lower 1/3. After adjusting the knobs on the magnifier, I can’t see the offset looking through the combo. Works well.
No, not at all. I was expecting something like +/- 0.002" tops. That is a broad tolerance. Thanks!
I use the stock Pro's QRP2 mount with the EOTech G33 (with the included spacer) and it dang near lines up perfect, maybe just a hair's difference. I don't notice a difference at all.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.