Red dot height

[P2Vaircrewman]

I have an Aimpoint PRO on my Colt 6940 with the Aimpoint supplied 1/3 co-witness riser and I find it a bit low. The stock pushes my ear muffs up and breaks the seal. Does anyone else have this problem. Being able to co-witness the irons is not a big deal for me. I normally have the front and rear sight folded down. I am interested in these risers, I just not sure on height.

https://www.skdtac.com/SKD-Aimpoint-QRP2-Riser-PRO-COMP-M4-p/skd.840.htm

[GH41]

None of us are built the same. Kinda hard for someone else to know what height is needed for you. If you are at lower 1/3 now the 1.93 spacer will jack you up 2 10ths. That's between 3/16s and 1/4" higher. Some of the other high mounts are 1.93. Have you tried other more compact muffs??

[P2Vaircrewman]

I am using Howard Leight Impact Sport, if there are any more compact I haven’t seen them. I usually end up using ear plugs when shooting the carbine but I miss the ease of communicating with the electronic muffs.