View Full Version : DPMS LR-308/AR-10 mag well dilemma
I am currently working on a personal project at work. Milling from billet DPMS lower receiver. After doing some research I have found what appears to be a mash up of a DPMS and AR lower receiver. This model has the Radius but the buffer tube thread vs the angle like the AR.... but has the mag well pitched 3 degrees like the AR versus the DPMS meg well being straight. What do I do here? Lol
What answer are you looking for? This thread is looking one and done to me.
Am I mistaken in thinking that the DPMS mag well has the be perpendicular to the barrel? Can I leave it 3 degrees off?
The AR-10B was designed to use modified M14 magazines. When used in the M14, the angle of the mag is not quite 90 degrees to the bore. It makes sense that the angle was maintained in the AR-10B for correct feeding, but I don't know for certain.
The other mag commonly used mag is what they call the KAC SR-25 pattern. This is the most common pattern used. It's based on the original AR-10 magazine as designed by Eugene Stoner. I tried a Lancer mag in an MP-10 (SR-25 pattern). The Lancer is straight with no external curve. When inserted in the magwell, the mag appears to be at an angle slightly less than 90 degrees towards the muzzle.
The AR-10B was designed to use modified M14 magazines. When used in the M14, the angle of the mag is not quite 90 degrees to the bore. It makes sense that the angle was maintained in the AR-10B for correct feeding, but I don't know for certain.
The other mag commonly used mag is what they call the KAC SR-25 pattern. This is the most common pattern used. It's based on the original AR-10 magazine as designed by Eugene Stoner. I tried a Lancer mag in an MP-10 (SR-25 pattern). The Lancer is straight with no external curve. When inserted in the magwell, the mag appears to have a slight angle.
Alright this was the answer I was looking for. Luckily I can wire edm the mag well. Either way I was going to wire it. Thanks for the info
Isn't the magwell already cut? I was assuming you were starting with an 80% lower. Are you machining from a solid block?
Isn't the magwell already cut?
No I’m make the lower receiver myself at work. So I’ll be making it from a solid block myself
Ah. Take photos. I'd like to see how the project progresses.
Ah. Take photos. I'd like to see how the project progresses.
I surely will I plan on making a few for myself is I order 5 pieces of billet cut to the size I need to start with it’s $38 for a lower
bamashooter
11-03-19, 14:37
I surely will I plan on making a few for myself is I order 5 pieces of billet cut to the size I need to start with it’s $38 for a lower
Pretty cool. Look forward to your work and welcome to the forum.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.