View Full Version : Width of Alignment rod?
Would anybody be able to take a pair of calipers to their bore alignment rod and tell me the actual thickness?
Sent from my iPhone using Tapatalk Pro
Mine is:
Main beam = avg .995 inches
Splined end = avg .741 inches
Hope that helps.
ETA: I see you edited your post. Per your original request, the measurements above are for the G Reaction Rod and not what your looking for.
Sent from my iPhone using Tapatalk
Would anybody be able to take a pair of calipers to their bore alignment rod and tell me the actual thickness?
Sent from my iPhone using Tapatalk Pro
What are you aligning with this alignment rod?
What are you aligning with this alignment rod?
I suspect suppressors, to eliminate round strike.
Maybe not.
I suspect suppressors, to eliminate round strike.
Maybe not.
Correct. Suppressor to bore alignment.
Sent from my iPhone using Tapatalk Pro
Are we supposed to guess what caliber the rod will be used with?
KITTEN_FRENZY
07-24-21, 20:58
I have a few suppressors incoming and bought some rods.
People recommended these:
5.56: https://www.zoro.com/zoro-select-water-hard-drill-rod-w1-732-02187-in-w1d7326/i/G4635915/?utm_source=ExactTarget&utm_medium=Email&utm_content=&utm_campaign=202005_OrderConfirm_Transactional_None_All_None_1&smtrctid=156818521
7.62: https://www.zoro.com/zoro-select-water-hard-drill-rod-w1-1964-02968-in-w1d19646/i/G4585454/?utm_source=ExactTarget&utm_medium=Email&utm_content=&utm_campaign=202005_OrderConfirm_Transactional_None_All_None_1&smtrctid=156818521
I'm impressed with the shipping. They ship in giant tubes so they don't get bent.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.