View Full Version : 80 Percent Arms/5D Tactical end mill options?
TacticalSpeed
10-12-21, 19:42
The end mills from %d eventually wear out. I have read posts of many folks finding quality end mills from McMaster Carr etc, but none for the router I use yet...the Makita RT0701C.
Can anyone help?
Why don't you get them from 5DT? Too cheap?
TacticalSpeed
10-18-21, 12:45
Why don't you get them from 5DT? Too cheap?
There are better options for less $ out there...
There are better options for less $ out there...
How about a link to these better options.
TacticalSpeed
10-18-21, 16:30
How about a link to these better options.
Google. I'm trying to find the right size for me. Are you just here to troll or going to add value? smh
5/16th, 3 or 4 flute
1/4" shank
2" OAL
Heat up the 5d piece and the old one slides right out and you slide the new one in.
I got this one and it cuts like butter
5/16" Square End Mill Standard Length HTC tool 120-3312 3FL
Sent from my SM-G991U using Tapatalk
TacticalSpeed
10-18-21, 17:54
5/16th, 3 or 4 flute
1/4" shank
2" OAL
Heat up the 5d piece and the old one slides right out and you slide the new one in.
I got this one and it cuts like butter
5/16" Square End Mill Standard Length HTC tool 120-3312 3FL
Sent from my SM-G991U using Tapatalk
Thank you
5/16th, 3 or 4 flute
1/4" shank
2" OAL
Heat up the 5d piece and the old one slides right out and you slide the new one in.
I got this one and it cuts like butter
5/16" Square End Mill Standard Length HTC tool 120-3312 3FL
Sent from my SM-G991U using Tapatalk
We started milling on Sunday and the 5D end mill wore out fast. Like too fast. First one cut fine then each subsequent one got worse and worse until we just stopped due to the chatter. We were cutting shallow and keeping it wet. Still noticeably duller only 3 lowers in. Going to try the one you mentioned here. Thanks.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.