Glockster35
12-01-06, 09:53
Is it possible to build a tack driver using an A2 profile 20" 1/7 twist barrel?
I have a barrel I bought years ago, that I don't think has ever had any rounds through it. I am considering purchasing a flat top upper later in the year to build into one of my next project uppers.
I think all I have that can be used on this project is the barrel, so I will have to buy everything needed including the flat top, free floating handguards and the rings and scope.
I will probably go with a Super Sniper 20x42, 30mm Scope for the glass.
I think the handguards will cost around $120, rings should be about $120, and the scope for about $300, the flat top will be about $100, a MPI bolt carrier group should be $130.
Eventually I will be looking at getting the MagPul Precision Rifle Stock (PRS), but it is not something I have to have right now.
Am I missing something here?
I have a barrel I bought years ago, that I don't think has ever had any rounds through it. I am considering purchasing a flat top upper later in the year to build into one of my next project uppers.
I think all I have that can be used on this project is the barrel, so I will have to buy everything needed including the flat top, free floating handguards and the rings and scope.
I will probably go with a Super Sniper 20x42, 30mm Scope for the glass.
I think the handguards will cost around $120, rings should be about $120, and the scope for about $300, the flat top will be about $100, a MPI bolt carrier group should be $130.
Eventually I will be looking at getting the MagPul Precision Rifle Stock (PRS), but it is not something I have to have right now.
Am I missing something here?