mrosamilia
02-01-09, 11:55
I hope someone can be of assistance. I just bought a Tac Star side saddle for my M4. I disassembled the trigger group per the enclosed instructions and was able to get the gun together as pictured/described. My problem was when I cycled the action the bolt would hold up midway through cycle. I was able to release some tension on the enclosed screw which replaced the factory Pin.
My concern is that this screw will work loose continually even if loc tited. I therefore would like to reassemble the gun to factory specs with the pin. Sounds easy enough but when I took it apart I was very excited and did not take not of how the various washers/lock washers were installed with the pin. I know I'm an idiot, but could really use some sort of help. I have been unable to come up with a diagram and have also received no help from the Benelli Forum.
Any help would relieve some great stress!!
My concern is that this screw will work loose continually even if loc tited. I therefore would like to reassemble the gun to factory specs with the pin. Sounds easy enough but when I took it apart I was very excited and did not take not of how the various washers/lock washers were installed with the pin. I know I'm an idiot, but could really use some sort of help. I have been unable to come up with a diagram and have also received no help from the Benelli Forum.
Any help would relieve some great stress!!