Daniel Defense

[DocMinster]

Any input on the Daniel Defense M4 as I held one yesterday and it looked as though they made a decent weapon.

Precision crafted from the highest quality material available today with meticulous attention to detail, The Daniel Defense M4 Carbine will prove to be the benchmark in the industry.
Lower Receiver: Mil-Spec with Enhanced Flared Magazine Well
Upper Receiver: Mil-Spec with Indexing Marks and M4 Feed Ramps
Barrel: 16″ Ordanance Grade 4150 MP Tested, Chrome Lined, 1:7 Twist, M4 Profile
Chamber: 5.56 NATO
Flash Hider: A2 Birdcage Flash Hider
Bolt Carrier Group: Mil-Spec MP Tested, Properly Staked Gas Key
Sights: Daniel Defense A1.5 Fixed Rear Sight; Pinned “F” Marked Front Sight Base
Rail System: Daniel Defense Omega X 12.0 FSP
Buttstock: MAGPUL MOE Buttstock & Mil-Spec 5 Position Receiver Extension
Magazine: MAGPUL 30 round PMag in Black
Vertical Grip: Daniel Defense A2 Styling Vertical Grip
Case: Comes with Custom Daniel Defense Full-Latch 30ft Impact Plastic Case
Made in the USA!

[Sam]

https://www.m4carbine.net/showthread.php?t=26107&page=3

The last couple of pages contain pictures and report from actual owners, mine included. I ran 100 rounds through it after zeroing the irons and Aimpoint, it did not skip a beat. The trigger is very good although they didn't use a match trigger.
I ordered mine at the SHOT show and it arrived exactly a month later.

[Iraqgunz]

Doc,

I have one, though I haven't had it in had my hands because of geographical issues. Based solely on the pics my wife sent and her less than amatuer observations she said it was a very nice weapon. The bolt carrier is staked properly and so are the castle nuts (on most, mine wasn't). I think there are a few others here on the boards that have fired them.