Decapper to remove gas tube roll pins

[Nathan_Bell]

I have bent several roll punches over last few months knocking the gas tube roll pin out of the FSB, Snap On guy accused me of purposefully doing it :D

The old Lee Loader kits had a decapping rod that works perfectly for it and I have yet to break it. You still need to use a punch to reinstall, or you will split the pin, but is very slick for knocking them out.

[Robb Jensen]

I use the gas tube roll pin punches from ADCO.

[Nathan_Bell]

I use the gas tube roll pin punches from ADCO.


Where's the fun in using the right tool for the right job?:D

[Robb Jensen]

Where's the fun in using the right tool for the right job?:D

:D The proper sized punch is a 5/64ths.