View Full Version : Magpul XTM Rail Panel - Best way to adjust?
If I need to cut down my magpul xtm rail panels whats the best way to cut them and leave a straight line? Any suggestions?
thopkins22
04-11-09, 00:24
I cut a couple with a hacksaw. Once the initial track is cut in the plastic, it's pretty easy to keep a straight line. I think a dremel tool would have been better/easier though.
Be warned that they do not fit as tightly once one of the locking tabs is gone.
HAIL-CAESAR
04-11-09, 01:12
I ground a couple down with a bench grinder. Used the side of a wheel and the ground down perfectly.
Dremil tool for me. Pain in the bum bum, but it worked.
HAIL-CAESAR
04-11-09, 01:18
The bench grinder took seconds each and they came out perfect. I'd try that.
HAMMERDROP
04-12-09, 13:00
sharp steak knife ... sounds hoosier (sorry Indianites) but works like a charm :rolleyes: ...
Michael
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.