PDA

View Full Version : SBR Form 1 questions


ChrisG19
01-17-07, 13:13
Sorry if this has been covered before:

1) For barrel length, am I stuck with the length I put on the Form 1?
2) My first build will be a 10.5; since I don't have an upper yet, what would be the OAL when installed on an LMT w/standard collapsible stock?

Thanks
Chris
edwin907
01-17-07, 14:01
You can put any length you like on it after it's registered.

It's about 27.5" OAL (stock extended, it's how they measure it!).
ChrisG19
01-17-07, 17:15
Thanks. One last question: I tried to make copies of the notarized forms but the raised stamp doesn't show up, will ATF have a problem with this?

TIA,
Chris
edwin907
01-17-07, 17:44
They didn't with mine, you couldn't see it at all on the copy of the Certification of Trust I sent them.
SuicideHz
01-21-07, 14:51
You do have to send in proof of citizenship forms, correct? Where do I get my hands on those? I'll be filling out a Form1 as a Trust...
Hoplophile
01-21-07, 15:44
You do have to send in proof of citizenship forms, correct? Where do I get my hands on those? I'll be filling out a Form1 as a Trust...
http://www.titleii.com/Forms.htm has all of the forms as pdfs. you can fill in the blanks and print them with everything all nice and legible.
SuicideHz
01-21-07, 16:37
They don't seem to have the Certificate of Citizenship but according to people on TOS, they didn't send them in with their RLT'd Form1s anyway.

Thanks for the info though- that's where my Form1 is coming from...

Do you guys suggest engraving THEN filling out the form and sending it in? There was a discussion regarding the "intelligence" of going this route in case something bad should happen while engraving or in transit.

What do you think?
Robb Jensen
01-21-07, 16:42
Even if it's not required to do the Certificate of Compliance what would it hurt? It's not like the CoC will delay you or something, not having it could delay you. Some examiners might be more sticklers than other ones.

Also have the engraving do before sending off your paperwork, that way it's already done when you get it back approved.
SuicideHz
01-21-07, 17:13
Where do I get a Citizenship card? I need two, right?
themadhatter
01-21-07, 18:40
Where do I get a Citizenship card? I need two, right?
http://www.atf.treas.gov/dcof/index.htm
SuicideHz
01-21-07, 19:15
It's the 5330.20, right? It turns out Titleii.com had those in pdf so I am all set.
Hoplophile
01-22-07, 00:18
It's the 5330.20, right? It turns out Titleii.com had those in pdf so I am all set.
You had me worried I was losing my mind for a moment. I was sure I'd gotten all of the forms from that site.
ChrisG19
01-22-07, 08:31
Also have the engraving do before sending off your paperwork, that way it's already done when you get it back approved.

Is there an engraver in NoVA?

Oops here it is: https://www.m4carbine.net/showthread.php?t=1757