KX3 Installation HELPPP

[nolacop]

I lost the damn instructions so i need some help. First off, do you need a certain degree of poundage or do you just hand tighten it on the threads? Is any type of oil or Loctite needed? Thanks.

[SinnFéinM1911]

I'm not sure of the exact Spec's, BUT if I had to assume, you SHOULD use Rocksett over LocTite and as for the Torque Spec - no idea.

Bottom line Check noveske Website or call.

Sorry for the non-help

[Robb Jensen]

I use the supplied crush washer and tighten until it lines up with the Noveske engraving on the left side and pig on the right. I try not to torque more than about 30ft lbs.