View Full Version : KX3 Installation HELPPP
I lost the damn instructions so i need some help. First off, do you need a certain degree of poundage or do you just hand tighten it on the threads? Is any type of oil or Loctite needed? Thanks.
SinnFéinM1911
01-22-07, 16:43
I'm not sure of the exact Spec's, BUT if I had to assume, you SHOULD use Rocksett over LocTite and as for the Torque Spec - no idea.
Bottom line Check noveske Website or call.
Sorry for the non-help
Robb Jensen
01-22-07, 19:56
I use the supplied crush washer and tighten until it lines up with the Noveske engraving on the left side and pig on the right. I try not to torque more than about 30ft lbs.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.