CharlieMike
07-24-09, 07:49
I am considering ordering one of the BCM stainless steel barrels discussed in this thread:
https://www.m4carbine.net/showthread.php?t=32033
I notice that there is only one dimple on the BCM barrel but I think all of the low profile gas blocks I've seen have two set screws.
What is the proper way to install a gas block on this type of dimpled barrel?
https://www.m4carbine.net/showthread.php?t=32033
I notice that there is only one dimple on the BCM barrel but I think all of the low profile gas blocks I've seen have two set screws.
What is the proper way to install a gas block on this type of dimpled barrel?