View Full Version : SBR???
Anyone know how hard it is to get a SBR approved in Maricopa County, AZ? Im going to order a new LMT upper tomorrow and im trying to figure out what length to get 16, 14.5 or 10.5 ? Decisions Decisions! Also what size rails fit on a standard 16inch upper?
Thanks
7" with a FSB and carbine gas system.
Will these work?
http://www.troyind.com/shop/product_info.php?cPath=24&products_id=76
Also any ideas for easy ones to install?
Thanks
Robb Jensen
03-01-07, 04:32
Will these work?
http://www.troyind.com/shop/product_info.php?cPath=24&products_id=76
Also any ideas for easy ones to install?
Thanks
Those are easy to install you can remove the barrel the conventional way and remove the delta ring, weld spring and snap ring or use a large set of bolt cutter or a Dremel to cut them. The Troy 7" will fit the LMT 10.5, 14.5 or 16, for an SBR I'd go 10.5"
I ordered the 14.5 today, I figured I could permately attach the flash hider to it if I had to and be covered. Im thinking going through the SBR process would be a pain? But I will look into it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.