PDA

View Full Version : Remington 700 PSS - bolt handle does not go all the way down


andy t
03-03-07, 19:32
Greetings,

I got a used Rem 700 PSS a few weeks ago. I had a chance to finally take it to the range today. I chambered a cartridge, took the safety off, press the trigger, Click. Ejectted the cartrige, and the primer didn't look like anything even hit. Upon further inspection, it seems that when the rifle is ready to fire, the bolt handle is not all the way down. Even applying slight pressure (which I shouldn't) it still doesn't go all the way down. I even compared it to a new Remington 700 in the store. The one in the store, had its bolt handle all the way down into the stock's recess.
I haven't done anything to the rifle since I got it. What could be causing this issue?

A few pictures to illustrate:

http://i90.photobucket.com/albums/k269/andy_t1/IMG_0972Large.jpg
http://i90.photobucket.com/albums/k269/andy_t1/IMG_0971Large.jpg
http://i90.photobucket.com/albums/k269/andy_t1/IMG_0970Large.jpg

This is the most I can get the bolt handle down with or without a cartridge being chambered

Thanks,

Andrew.
usmcgrunt
03-03-07, 21:12
Andrew have you tried putting the safety on "safe" and then see if it will go down, the same for "fire" position? Seems I have heard of this before just not sure what the remedy was! Good luck! Have you tried removing the bolt completely and re-inserting?

Grunt Out!
andy t
03-03-07, 21:58
USMCGRUNT,

It was "operator error". My recently installed scope mount had screws that were a little too long, causing the blot not to close completely.

Arr!

Andrew.
carshooter
03-03-07, 22:00
Was the scope already installed on it when you bought it?

Will the bolt handle go down without a round in it? If the bolt handle will not go all the way down on an empty chamber, I bet that the mount screws on the front scope base are sticking through into the receiver contacting the bolt.

Basically, the screws are reversed. (longer rear base screws in the front holes)
carshooter
03-03-07, 22:01
Oops, I was too late.
andy t
03-03-07, 22:16
carshooters,

Still, thanks!
I got with a different, ugly mount. I ended up having to remove a stippred screw from that mount before putting the Leupold mount on.
carshooter
03-04-07, 10:32
The only reason I knew what it was right away is because I've done that a time or two, myself!
sgtlmj
03-16-07, 23:00
I was going to pop in and tell you that your screws were too long just by reading the subject.

Don't ask me how I know. :D