gixer6
11-24-09, 13:00
i built a lower yesterday to go with a tac sol .22 upper using a RRA 2-stage trigger. i noticed when i pull the trigger and hold it back, the trigger doesnt reset when i cycle the bolt. to get it to reset you have to let go of the trigger before you cycle it.
ive seen a few people on here using this same upper/trigger combo, so it should work unless i did something wrong or need to tune something a little.
i just put a 556 upper on the lower and it works fine. it also resets properly when i have just the lower and push the hammer down with my thumb...i dont feel any binding or anything.
it must just have something to do with the .22 bolt. maybe i cant pull it back far enough with the charging handle..but a live round will?
ill take another look at it later today, but its hard for me to tell whats going on as it only does it with the lower connected to the upper.
anyone with this same upper and trigger mind letting me know if yours does this also? thanks
ive seen a few people on here using this same upper/trigger combo, so it should work unless i did something wrong or need to tune something a little.
i just put a 556 upper on the lower and it works fine. it also resets properly when i have just the lower and push the hammer down with my thumb...i dont feel any binding or anything.
it must just have something to do with the .22 bolt. maybe i cant pull it back far enough with the charging handle..but a live round will?
ill take another look at it later today, but its hard for me to tell whats going on as it only does it with the lower connected to the upper.
anyone with this same upper and trigger mind letting me know if yours does this also? thanks