Kilo 1-1
11-26-09, 01:25
Finally got around to stippling 2 of my extra KAC panels. I used a dremel to sand off the ribs, then used a soldering iron. I also stippled some magpul XTM panels a few weeks earlier as a practice run.
http://img7.imageshack.us/img7/6345/flatq.jpg
http://img8.imageshack.us/img8/1720/processm.jpg
http://img4.imageshack.us/img4/8908/compareprepost.jpg
http://img16.imageshack.us/img16/169/kaclogo.jpg
http://img7.imageshack.us/img7/1002/stipledkacpanels.jpg
http://img18.imageshack.us/img18/449/ras1q.jpg
http://img20.imageshack.us/img20/4568/ras2f.jpg
http://img7.imageshack.us/img7/7317/sideie.jpg
http://img4.imageshack.us/img4/6138/side2zd.jpg
I actually like this setup. KAC panels were relatively thin, but getting rid of the ribs and stippling it reduced the thickness by a little bit while increasing the grip-ability.
Thanks to those individuals who answered my questions in the last thread.
http://img7.imageshack.us/img7/6345/flatq.jpg
http://img8.imageshack.us/img8/1720/processm.jpg
http://img4.imageshack.us/img4/8908/compareprepost.jpg
http://img16.imageshack.us/img16/169/kaclogo.jpg
http://img7.imageshack.us/img7/1002/stipledkacpanels.jpg
http://img18.imageshack.us/img18/449/ras1q.jpg
http://img20.imageshack.us/img20/4568/ras2f.jpg
http://img7.imageshack.us/img7/7317/sideie.jpg
http://img4.imageshack.us/img4/6138/side2zd.jpg
I actually like this setup. KAC panels were relatively thin, but getting rid of the ribs and stippling it reduced the thickness by a little bit while increasing the grip-ability.
Thanks to those individuals who answered my questions in the last thread.