Stainless Recce Upper . . . Twist Rate?

[BravoCompanyUSA]

Just wondering the twist rate preferred by most folks if they were designing their own perfect 16" Mid length upper ?

[Aubrey]

Paul,

Very interesting that you should post this. A hint to future offerings perhaps?

I expect that you'll likely get more votes for 1/7" due to the mindset that we need to stabilize L-110 tracers in arctic conditions. I believe, however, that 1/8" is sufficient for 75-77gr bullets and will be slightly more accurace, all else being equal.

[BravoCompanyUSA]

My wheels are always turning, but not really a hint at much . . . . just thinking out loud at this point.
There is always a bunch of ideas on the "drawing board", but in reality there is never enough time in the day to get even 5% of them to the shelf.

I've had this discussion with a variety of industry folks many times in the past, so I thought it would be a good idea just to pose the question.

[9DivDoc]

What kinda contour you thinkin?

[-H-]

My vote is for 1 - 7.7

Hey you asked.