View Full Version : M&P 9/40/45 FS/C All take the same dimension sights?
RadioActivity
03-02-10, 03:30
...Hurts my brain...
So, am I correct? Perhaps the slide dovetails are milled at different heights.
But the bottom line is if I want to replace factory sights with Warren's...I'm ordering several sets of the same sight for each caliber/size pistol?
Robb Jensen
03-02-10, 07:21
...Hurts my brain...
So, am I correct? Perhaps the slide dovetails are milled at different heights.
But the bottom line is if I want to replace factory sights with Warren's...I'm ordering several sets of the same sight for each caliber/size pistol?
All the Trijicon sights are the same.
Warren Tactical makes sights that fit the majority of the M&Ps and a special set with a taller front sight that's for 5" M&Ps (Pro and 9L).
A related question: Does the M&P require any special tool like a sight pusher to replace the sights? Or is it a pretty easy swap after the locking screw is removed?
A related question: Does the M&P require any special tool like a sight pusher to replace the sights? Or is it a pretty easy swap after the locking screw is removed?
Yes and no. The rear sight is easy to push out. The front, not so much.
C4
RadioActivity
03-02-10, 21:52
Thanks guys!
Yes and no. The rear sight is easy to push out. The front, not so much.
C4
Depends on how old/new your pistol is. My newer M&P's were a cinch when it came to removing the rear sights.
My older M&P's were impossible lol.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.