Colt 9mm Extraction Issues

[Rogueplayer]

Looking for some confirmation

Have a 9mm Colt 10.5 complete upper
Colt Lower and top loading Hahn block

Have about 1000-1200 rounds through it.

Recently having many stovepipes with all of the magazines. Colt mags and Wolff springs or Colt mags with stock springs.

What is the average life on the extractor? Any tweaking?

Pulled it out and cleaned it on two occasions and installed a new pin.

Thinking of ordering a new extractor?

Thanks in advance
Brook

[Robb Jensen]

What ammo?

[Rogueplayer]

Varied
Speer Lawman 115 gr
Remington 115 +p & +p+
Federal 147
Doubletap
UMC.
Just about everything.

[Robb Jensen]

I think I would closely inspect the extractor, it may be chipped and need a new one.

[-Wes-]

The ejector too.

[Snake RAH]

If both parts (extractor and ejector) look good, then have you moved your mag block any? I've found with my RRA that there is a sweet spot where it works (a hair too high or low and the weapon malfunctions in either feeding or ejection).

[hoveyh]

I do Not have specific help but I have that exact upper and block.
Do Not overlook Anyting scrutinize Everyting. My upper had a loose barrel nut from
Colt factory. Hahn block dropped in my Anderson lower Tight as can be perfect alignment.
Mines been Perfect fmj Not jhp. I run 8oz buffer and std spring. Yes look at extractor closely
I did Not touch Hahn ejector. Could it be a timing issue if you are running lighter
Buffer??