Which 6.8 SPC magazines are you using?

[RAM Engineer]

Any informed advice welcomed!

[curious1]

The Barrett mags are nice.

[Spooky130]

I have C-Product mags. Only two of them actually. In one mag, the rounds feeding from the right side hang up when feeding. The other mags works great. Not much of a test group but a little insight...

Spooky

[Stephen_H]

I have 28 CProducts mags. They have all been basically 100% reliable and they all drop free from my two 6.8mm's (a Stag and an LWRC). I had to tweak the feed lips slightly so that they would run with the SSA X-Treme load, but that is a problem with the ammo and not the mag it would seem.

Stephen

[FlyingHunter]

I prefer C-Products mags. I have 2 PRI and 4 C-P mags. They have both fed 100%, however the PRI's are dang hard to fully load and do not drop freely as well as the CP from my Colt lower.

[Hawkeye]

Based on my limited time with them, I'd have to rate the Barrett mags the best, with PRI's a very close second.

[DocGKR]

Concur.

[Stephen_H]

Also, I recently aquired an AAC 6.8mm suppressor. I did some shooting with water in the can recently to see if/how much it increased sound reduction. By the the time I got back from the range the two PRI mags I was using (a 10 and a 15 round) were covered in a layer of rust. The CProducts mags didn't do that.

Stephen

[Armati]

A little OT but does anyone make a straight walled 20 or 25rd 6.8 mag?

IMO a straight 25rd mag would be perfect.

[TimP]

Barrett