View Full Version : bolt carrier assembly
syclone170
05-13-10, 12:35
I was going to order a new bolt carrier assembly to replace my current one and use the old one as a spare, but I forgot that my DPMS will not work with a supposedly tier 1 or tier 2 bolt carrier assembly. I will have to order from Stag it looks like..
Robb Jensen
05-13-10, 12:53
Why would a DPMS upper not work with a better than DPMS carrier?
sounds like someone has been mislead.
syclone170
05-13-10, 13:21
Sorry guys, should have explained that it is a lefty...
I don't think they are the same as Stag left hand carriers.
Robb Jensen
05-13-10, 13:29
I'd get a Stag LH upper receiver and a Stag LH BCG. I'd also remove the carrier key, use new carrier key screws, torque and stake it properly before using. Stag does a horrible job of staking carriers I've fixed dozens that have come lose.
syclone170
05-13-10, 17:55
I'd get a Stag LH upper receiver and a Stag LH BCG. I'd also remove the carrier key, use new carrier key screws, torque and stake it properly before using. Stag does a horrible job of staking carriers I've fixed dozens that have come lose. That's good to know, thanks..
I've seen a left handed DPMS and I was not impressed at all. It looked like they took a standard upper receiver, cut the ejection port on the opposite side, used a standard BCG and just used a different bolt head. I could see (and remove) the cotter pin through the ejection port. :mad: As I said, not impressed.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.