New DD Low Pro Gasblocks

[Col_Crocs]

Anyone seen these yet or lucky enough to have been asked to do T&E?
http://www.danieldefense.com/?page=shop/detail&product_id=283
It's about time they came out with their own low-pro GB and they did an awesome good job IMHO. I especially like how it comes pre-drilled for a pin. It would be even cooler if they shipped these out complete with a proper length straight and taper pin.

[rob_s]

Interesting. Wonder if they're going to do a .625" as that would save me a significant amount of trouble...

[Col_Crocs]

Yup they do. :)
http://www.danieldefense.com/?page=shop/detail&product_id=284

[rob_s]

Yup they do. :)
http://www.danieldefense.com/?page=shop/detail&product_id=284

Interesting. Would have preferred that the wall thickness stay the same and the OD come down as well but understand from a manufacturing standpoint why they wouldn't do that.

.750"
http://www.danieldefense.com/img/product/4bfa40cb5b650b222402bdae1cceb0fb.jpg


.625"
http://www.danieldefense.com/img/product/257e4bf8fc24b80f609584284daa6476.jpg


http://www.danieldefense.com/img/product/4bfa40cb5b650b222402bdae1cceb0fb.jpghttp://www.danieldefense.com/img/product/257e4bf8fc24b80f609584284daa6476.jpg

[TehLlama]

Chaaa... ching. That would appear to suit my needs quite well.

[Col_Crocs]

Interesting. Would have preferred that the wall thickness stay the same and the OD come down as well but understand from a manufacturing standpoint why they wouldn't do that.

Come to think of it, yes, that would be great. Would give you more clearance under an Omega X but yeah, may not make sense from a manufacturing stand point. Although since it is CNC machined from what I assume is a pre-set blank, it may not be too difficult nor too expensive to produce a proportionally thinner gas block for .625 barrels. I could be wrong though.
From an aesthetics standpoint, it would be cool if they offered pinned type extended ones as well.