SAM-5S project

[buddyhoohaw]

I recently picked up an IWD milled stockset from RPB Industries for $25.00. I assume it was factory seconds because it had a few tooling marks and gauges not to metion it was dirt cheap. I sanded it with 150 to 600 grit paper followed by Chestnut Ridge Military stain and finally 5 coats of tung oil. The furniture was an early fathers day gift for my dad and he was pretty stoaked!! I also dig the Warsaw length buttstock since I shoot NTCH.

http://i5.photobucket.com/albums/y198/buddyhoohaw/SAM-5S/SAM-1.jpg

http://i5.photobucket.com/albums/y198/buddyhoohaw/SAM-5S/SAM-2.jpg

http://i5.photobucket.com/albums/y198/buddyhoohaw/SAM-5S/SAM-3.jpg

http://i5.photobucket.com/albums/y198/buddyhoohaw/SAM-5S/SAM-8.jpg

http://i5.photobucket.com/albums/y198/buddyhoohaw/SAM-5S/SAM-4.jpg

http://i5.photobucket.com/albums/y198/buddyhoohaw/SAM-5S/SAM-5.jpg

http://i5.photobucket.com/albums/y198/buddyhoohaw/SAM-5S/SAM-6.jpg

http://i5.photobucket.com/albums/y198/buddyhoohaw/SAM-5S/SAM-7.jpg

[Akoni]

Great rifles those SA-M5's. And that furniture looks so much better than the plastic originals. Good job.

[VA_Dinger]

Wow, that really looks great.

You did an swesome job on the furniture refinishing.

[buddyhoohaw]

Thanks guys. To finish it off I would like to replace the muzzle break with a slant break or possibly an A2.