View Full Version : Need help installing Specter Gas Block.
freedomvet
01-06-11, 00:54
When installing a Specter Gas Block,instructions state I need to leave a 1/32" gap between the shoulder of the barrel and the Gas Block itself. I believe this is to ensure the gas ports in both barrel and block align. What's the best way to determine the gap size ? Other than using a ruler, etc. are there any other tricks of the trade? My build is almost complete and am completing it with the install of a free float handguard. Thanks to all !
Seems like a feeler guage would be the wat to go. Should be able to find one at any auto parts store.
Go with a feeler gauge, an alternative would be a handguard cap dremeled in halve.
A credit card is .02999" and 1/32 is .031". That'd probably get you there just fine.
freedomvet
01-07-11, 10:21
Thanks for the tips guys. I had thought of the handguard cap but my suppressor is pinned on. Never thought of cutting it in half.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.