View Full Version : Smith Enterprises 9mm Vortex F/H
freedomvet
01-20-11, 23:10
Changing the A1 flash hider on my Colt 6450 with a Smith Enterprises 9mm Vortex Flash Hider. It didn't come with a crush washer. Is it necessary to use one, in order to mount the F/H ? Thanks!
No crush washer necessary on the Smith Vortex. Simply apply a little anti seize and install it finger tight.
freedomvet
01-23-11, 17:00
No crush washer necessary on the Smith Vortex. Simply apply a little anti seize and install it finger tight.
Thank you for the help !
No crush washer necessary on the Smith Vortex. Simply apply a little anti seize and install it finger tight.
If you only have to install it finger tight, why does it have wrench flats? I would certainly put a little more torque on it than just your fingers.
No crush washer necessary on the Smith Vortex. Simply apply a little anti seize and install it finger tight.
That depends upon the particular model of Smith Vortex. Smith recommends that the Vortex be torqued to 10 ft-lbs. No anti-seize is necessary.
http://www.box.net/shared/static/xrxrkmmivv.jpg
http://www.box.net/shared/static/8ucpi051u2.jpg
http://www.box.net/shared/static/v0cc36i6fp.jpg
http://www.box.net/shared/static/0iob6xq2cf.jpg
http://www.box.net/shared/static/73534k35rx.jpg
….
I believe they designed it to self-tight when shooting.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.