86K5
03-31-11, 08:03
Ok so here is how my AR sits now:
http://i838.photobucket.com/albums/zz306/Rico762/012-2.jpg
RRA upper with a BCM BCG and a DD CHF barrel, RRA lower with a RRA LPK, A2 stock, MOE fore arm and it now has a MOE PG. Magpul rear sight.
Here is what I have planned next.
Replace trigger group with a DD or BCM when I can find one in stock. Besides the obvious, the RRA has a nasty reset.
Shave the front sight down to fit under a FF tube.
Replace the MOE handguard with an Apex Machining rifle length tube, this one, http://www.apexcncmachine.com/store.php?seller=ApexMachiningCompany&navt1=19974&pd=112348 , with the top rail only or this one, http://www.rainierarms.com/?page=shop/detail&product_id=2563 . I don't wish to remove the front sight to install a FF tube since Daniel Defense was nice enough to install the bbl and all on my upper and the front sight pins are extremely tight so I want a tube I can slip over and do not want a lot of rails.
Replace the birdcage flashider with an AAC.
Drop a 1-4 power scope on it.
After all that I think it will be where I want it.
Thoughts, comments, suggestions?
http://i838.photobucket.com/albums/zz306/Rico762/012-2.jpg
RRA upper with a BCM BCG and a DD CHF barrel, RRA lower with a RRA LPK, A2 stock, MOE fore arm and it now has a MOE PG. Magpul rear sight.
Here is what I have planned next.
Replace trigger group with a DD or BCM when I can find one in stock. Besides the obvious, the RRA has a nasty reset.
Shave the front sight down to fit under a FF tube.
Replace the MOE handguard with an Apex Machining rifle length tube, this one, http://www.apexcncmachine.com/store.php?seller=ApexMachiningCompany&navt1=19974&pd=112348 , with the top rail only or this one, http://www.rainierarms.com/?page=shop/detail&product_id=2563 . I don't wish to remove the front sight to install a FF tube since Daniel Defense was nice enough to install the bbl and all on my upper and the front sight pins are extremely tight so I want a tube I can slip over and do not want a lot of rails.
Replace the birdcage flashider with an AAC.
Drop a 1-4 power scope on it.
After all that I think it will be where I want it.
Thoughts, comments, suggestions?