YVK
04-05-11, 16:08
Components: BCM midlength upper, BCM F/A BCG, LaRue low profile gas block, PWS FSC 5.56 permanently pinned. The charging handle is PRI Gasbuster.
This upper was built by ADCO on my order when nobody, besides Noveske, was offering 14.5 middies. It started as a 16 inch middy (hammer forged weren't available then) which was cut and recrowned, FSB was knocked off and LaRue gasblock installed, DD rail installed and PWS unit pinned.
Disclaimers: 1. I have shot 3500 rounds through it, so it is used. Incidentally, it is my most tested upper that has been awesome - 100% function with wide range of ammo in temps from 22 to 115F.
2. It is painted with two layers Krylon from a rattle can - functional but by all means not an artwork.
Pricing: new upper in this setup is about $1130 (900 upper, 90 ch, 130 bcg), and it is out of stock. I am knocking 30% off for mileage and paint, and selling it for $800 shipped.
No trades, price is firm, photos on request.
This upper was built by ADCO on my order when nobody, besides Noveske, was offering 14.5 middies. It started as a 16 inch middy (hammer forged weren't available then) which was cut and recrowned, FSB was knocked off and LaRue gasblock installed, DD rail installed and PWS unit pinned.
Disclaimers: 1. I have shot 3500 rounds through it, so it is used. Incidentally, it is my most tested upper that has been awesome - 100% function with wide range of ammo in temps from 22 to 115F.
2. It is painted with two layers Krylon from a rattle can - functional but by all means not an artwork.
Pricing: new upper in this setup is about $1130 (900 upper, 90 ch, 130 bcg), and it is out of stock. I am knocking 30% off for mileage and paint, and selling it for $800 shipped.
No trades, price is firm, photos on request.