PDA

View Full Version : F marked front sight gas block


chizuck
04-25-11, 21:24
Does anyone make one that does not have a bayonet lug or sling swivel?

Sorry if this has been covered.

Chuck
Omega_556
04-25-11, 21:30
http://www.bravocompanyusa.com/AR15-Front-Sight-F-Marked-p/front%20sight%20base%20-%20f%20750.htm
chizuck
04-25-11, 21:35
http://www.bravocompanyusa.com/AR15-Front-Sight-F-Marked-p/front%20sight%20base%20-%20f%20750.htm

Thanks but that one has the bayonet lug and sling swivel that I do not want. If nothing else I will get that one and mod it.
Omega_556
04-25-11, 21:39
Does anyone make one that DOES have a bayonet lug or sling swivel?


I'm sorry, in your original post I thought you wanted one that DOES have a bayonet lug.

Good luck in your search.
chizuck
04-25-11, 21:42
I'm sorry, in your original post I thought you wanted one that DOES have a bayonet lug.

Good luck in your search.

No prob it was my fault and thanks again.
SomeOtherGuy
04-25-11, 22:12
If one exists, it can probably be found at at least one of:
Brownells
MidwayUSA
Stag Arms (they sell parts too)
Armalite Inc. (ditto)
Eurodriver
04-26-11, 01:26
Do you own a dremel? Honest question.
ZRH
04-26-11, 02:20
You may have to call because they aren't going to be popular, installing an undrilled FSB is-- I can't imagine doing it without a drill press.

I'd also try http://www.sarcoinc.com/m16.html

If everyplace else fails there is http://www.specializedarmament.com/ It will cost an arm and a leg but they got almost everything.

ETA: I'm pretty certain sling swivels are standard.
Mark71
04-26-11, 02:49
I have one available. PM sent
GTifosi
04-26-11, 06:20
please delete this non~relevant post
chizuck
04-26-11, 13:20
Do you own a dremel? Honest question.

Yeah I got a dremel :D just wanted to try to buy one first.
Eric
04-26-11, 21:20
Just keep in mind that pinned front sight assemblies are not interchangeable from one barrel to another. The assembly is installed on the barrel and then the taper pin channels are drilled through the assembly and into the edge of the barrel.
chizuck
04-26-11, 22:36
Thanks to everyone, mark71 got me covered. I knew that I could just cut the lug and swivel off but figured if I could buy one it would be easier. I don't live in a ban state or anything I just don't need them and think it will look cleaner with out the extra stuff.

This is a great forum thanks again everyone.