View Full Version : Getting a new rail,have a question?
I'm gonna order a Centurion for my LMT 16" upper.Either a 10" or 12".Any big reasons to go with one size over the other?
Guns-up.50
05-31-11, 21:45
If your not too worried about weight i would go with the 12" if you dont use the extra 2 inches so be it but if you need it and is not there you S.O.L. The saying goes better to have it and not need it then to need it and not have it
IMO, if you're going to ditch the factory front sight, might as well put a long rail on the gun to increase sight radius. Otherwise just install a factory length rail for your gas system & use the rigid A2 sight.
Anybody have a pic of a 10" and 12" to compare?(16" barell)
Anybody have a pic of a 10" and 12" to compare?(16" barell)
They have pictures on their web site. Just click on the rail you are looking at and the pictures are at the bottom of the page.
Check out this thread. Good info.
https://www.m4carbine.net/showthread.php?t=74894
Thanks guys,went with the 10".
.Either a 10" or 12".Any big reasons to go with one size over the other?
Oddly enough, Army Times just posted an article on this subject.....
http://militarytimes.com/blogs/gearscout/2011/06/01/the-mother-of-all-rail-articles/
Oddly enough, Army Times just posted an article on this subject.....
http://militarytimes.com/blogs/gearscout/2011/06/01/the-mother-of-all-rail-articles/
Great article,now i just need to figure out what BUIS's and gas block!(or to cut my fsb)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.